YouTubeFabrication Sheet · Living Room
DIY IKEA HACK KALLAX TRANSFORMATION | FLUTED SIDEBOARD
Original thumbnail and video · Kristen McGowan
Watch original post ↗Estimated Cutlist adaptation inspired by the video; not the creator’s verified or endorsed plan. Tags are editorial search keywords, not confirmed hashtags from the original description. Current popularity and trending rank have not been verified.
#IKEA #KALLAX #flutedsideboard #ikeahack #DIY
Identified base piece
IKEA KALLAX 2×4
Art. · €84–€114 · IKEA Portugal
Materials & cuts
- KALLAX door inserts — measure actual fronts × 8IKEA · Bulky€82–€110Buy ↗
- Pine half-round moulding 12 × 6 mm × 40 lengths of 2400 mm; estimated with spareBauhaus · Bulky€41–€55Buy ↗
- Surface-compatible adhesive and primer × 1 + 1Amazon · Small€20–€28Buy ↗
- Paint and cabinet pulls × 1 tin + 8 pullsAmazon · Small€17–€23Buy ↗
Flutes: 27 per door × 8; adjust to actual width
Qty 216- Length
- 330mm
- Width
- 12mm
- Thickness
- 6mm
Pine half-round moulding · Edge: Sand ends; verify each door-front height
Fit is not verified: check dimensions, hardware and cutting layout before buying.
Toolbox
↺ Beginner swap: Order sized cuts at the store
Safety & PPE
- Do not copy dimensions without measuring the doors. Test-fit a single flute first.
- Do not fasten legs into hollow-core panels. This adaptation retains the original base and requires suitable anti-tip anchoring.
- Check every door swing before gluing flutes near hinges.
Estimated budget
- Base piece€84 – €114
- Dimensioned lumber & sheet goods€122 – €166
- Hardware & consumables€37 – €51
Most likely estimate€287.00
Step by step
Preparation
- 01Watch the original video. This adaptation uses a horizontal 2×4 KALLAX with eight door inserts and leaves the frame intact.
- 02Assemble following IKEA instructions. Measure each front and its opening clearance; record height, width and thickness. The 330 mm value is only an estimate.
Cutting
- 03Cut one flute to the measured height, sand and test the door swing. Set the stop block only after this trial.
- 04Cut remaining flutes in door-sized batches. Allow about 27 flutes per 330 mm front; adjust quantity to usable width and purchased profile.
Assembly
- 05Remove doors, clean and prepare surfaces to the adhesive manufacturer’s instructions. Make a bond test and observe cure time.
- 06Dry-lay flutes from the centre outwards, maintaining clearances. Clamp with a flat protective caul without warping doors.
Finishing
- 07Sand ends and apply primer and thin paint coats. Keep buildup away from hinges.
- 08Refit doors, adjust hinges and anchor the unit to the wall with suitable fixings. Check the manual before adding loads.
Unlock the full cut list, printable guide and Workshop Mode for this project.